HP HSR6800 Configuration Manual page 405

Step
3. Configure a network entity
title for the IS-IS process.
4. Enable the IPv6 capacity for
the IPv6 IS-IS process.
5. Redistribute remote site
routes advertised by the PE.
6. Return to system view.
7. Enter interface view.
8. Enable the IPv6 IS-IS
process on the interface.
For more information about IPv6 IS-IS, see Layer 3—IP Routing Configuration Guide.
Configuring EBGP between an MCE and a VPN site
To use EBGP for exchanging routing information between an MCE and IPv6 VPN sites, you must
configure a BGP peer for each IPv6 VPN instance on the MCE, and redistribute the IGP routes of
each VPN instance on the IPv6 VPN sites.
If EBGP is used for route exchange, you also can configure filtering policies to filter the received
routes and the routes to be advertised.
1. Configure the MCE:
Step
1. Enter system view.
2. Enter BGP view.
3. Enter IPv6 BGP-VPN
instance view.
4. Specify an IPv6 BGP peer in
an AS.
5. Redistribute remote site
routes advertised by the PE.
6. Configure a filtering policy to
filter the routes to be
advertised.
7. Configure a filtering policy to
filter the received routes.
Command
network-entity net
ipv6 enable
ipv6 import-route protocol
[ process-id ] [ allow-ibgp ] [ cost
cost | [ level-1 | level-1-2 |
level-2 ] | route-policy
route-policy-name | tag tag ] *
quit
interface interface-type
interface-number
isis ipv6 enable [ process-id ]
Command
system-view
bgp as-number
ipv6-family vpn-instance
vpn-instance-name
peer ipv6-address as-number
as-number
import-route protocol
[ process-id [ med med-value |
route-policy route-policy-name ]
* ]
filter-policy { acl6-number |
ipv6-prefix ip-prefix-name }
export [ direct | isisv6 process-id
| ripng process-id | static ]
filter-policy { acl6-number |
ipv6-prefix ip-prefix-name }
import
397
Remarks
Not configured by default.
Disabled by default.
Optional.
By default, no routes from any
other routing protocol are
redistributed to IPv6 IS-IS.
If you do not specify the route
level in the command,
redistributed routes are added to
the level-2 routing table by
default.
N/A
N/A
Disabled by default.
Remarks
N/A
N/A
N/A
N/A
By default, No route redistribution
is configured.
Optional.
By default, the MCE does not filter
the routes to be advertised.
Optional.
By default, the MCE does not filter
the received routes.