HP HSR6800 Configuration Manual page 432

[PE2-Serial2/1/1] mpls
[PE2-Serial2/1/1] mpls ldp
[PE2-Serial2/1/1] quit
# Configure interface Loopback 0 and start IS-IS on it.
[PE2] interface loopback 0
[PE2-LoopBack0] ip address 5.5.5.9 32
[PE2-LoopBack0] isis enable 1
[PE2-LoopBack0] quit
# Create VPN instance vpn1 and configure the RD and route target attributes for it.
[PE2] ip vpn-instance vpn1
[PE2-vpn-instance-vpn1] route-distinguisher 11:11
[PE2-vpn-instance-vpn1] vpn-target 3:3 import-extcommunity
[PE2-vpn-instance-vpn1] vpn-target 3:3 export-extcommunity
[PE2-vpn-instance-vpn1] quit
# Configure interface Loopback 1 and bind the interface to VPN instance vpn1.
[PE2] interface loopback 1
[PE2-LoopBack1] ip binding vpn-instance vpn1
[PE2-LoopBack1] ipv6 address 2001:1::2 128
[PE2-LoopBack1] quit
# Start BGP.
[PE2] bgp 600
# Configure the capability to advertise labeled routes to and receive labeled routes from IBGP
peer 4.4.4.9.
[PE2-bgp] peer 4.4.4.9 as-number 600
[PE2-bgp] peer 4.4.4.9 connect-interface loopback 0
[PE2-bgp] peer 4.4.4.9 label-route-capability
# Configure the maximum hop count from PE 2 to EBGP peer 2.2.2.9 as 10.
[PE2-bgp] peer 2.2.2.9 as-number 100
[PE2-bgp] peer 2.2.2.9 connect-interface loopback 0
[PE2-bgp] peer 2.2.2.9 ebgp-max-hop 10
# Configure peer 2.2.2.9 as a VPNv6 peer.
[PE2-bgp] ipv6-family vpnv6
[PE2-bgp-af-vpnv6] peer 2.2.2.9 enable
[PE2-bgp-af-vpnv6] quit
# Redistribute direct routes to the routing table of vpn1.
[PE2-bgp] ipv6-family vpn-instance vpn1
[PE2-bgp-ipv6-vpn1] import-route direct
[PE2-bgp-ipv6-vpn1] quit
[PE2-bgp] quit
5. Verify the configuration:
# From each PE, ping the other PE. PE 1 and PE 2 can ping each other:
[PE2] ping ipv6 –vpn-instance vpn1 2001:1::1
PING 2001:1::1 : 56
Reply from 2001:1::1
bytes=56 Sequence=1 hop limit=64
Reply from 2001:1::1
bytes=56 Sequence=2 hop limit=64
Reply from 2001:1::1
data bytes, press CTRL_C to break
time = 1 ms
time = 1 ms
424