HP HSR6800 Configuration Manual page 93

The Maximum Transmit Unit is 64000
Internet Address is 6.1.1.1/24 Primary
Encapsulation is TUNNEL, service-loopback-group ID not set
Tunnel source unknown, destination 3.3.3.3
Tunnel protocol/transport CR_LSP
Output queue : (Urgent queuing : Size/Length/Discards)
Output queue : (Protocol queuing : Size/Length/Discards)
Output queue : (FIFO queuing : Size/Length/Discards)
Last 300 seconds input:
Last 300 seconds output:
0 packets input,
0 input error
0 packets output,
0 output error
Execute the display mpls te tunnel command on each router to view information about the
MPLS TE tunnel.
[RouterA] display mpls te tunnel
LSP-Id Destination
1.1.1.1:1 3.3.3.3
[RouterB] display mpls te tunnel
LSP-Id Destination
- -
[RouterC] display mpls te tunnel
LSP-Id Destination
- -
Execute the display mpls lsp command or the display mpls static-cr-lsp command on each
router to view information about the static CR-LSP.
[RouterA] display mpls lsp
-------------------------------------------------------------------
LSP Information: STATIC CRLSP
-------------------------------------------------------------------
FEC In/Out Label
3.3.3.3/32 NULL/20
[RouterB] display mpls lsp
------------------------------------------------------------------
LSP Information: STATIC CRLSP
------------------------------------------------------------------
FEC In/Out Label
-/- 20/30
[RouterC] display mpls lsp
------------------------------------------------------------------
LSP Information: STATIC CRLSP
------------------------------------------------------------------
FEC In/Out Label
-/- 30/NULL
[RouterA] display mpls static-cr-lsp
total statics-cr-lsp : 1
Name FEC
Tunnel0 3.3.3.3/32
0 bytes/sec, 0 packets/sec
0 bytes/sec, 0 packets/sec
0 bytes
0 bytes
In/Out-If
-/GE2/1/1
In/Out-If
GE2/1/1/GE2/1/2
In/Out-If
GE2/1/1/-
In/Out IF
-/GE2/1/1
In/Out IF
GE2/1/1/GE2/1/2
In/Out IF
GE2/1/1/-
I/O Label
NULL/20
85
0/100/0
0/500/0
0/75/0
Name
Tunnel0
Name
Tunnel0
Name
Tunnel0
Vrf Name
Vrf Name
Vrf Name
I/O If State
-/GE2/1/1 Up