Inter-As Mpls Te Tunnel Using Rsvp-Te Configuration Example - HP HSR6800 Configuration Manual

Route Pinning
Retry Limit
Reopt
Back Up Type
Back Up LSPID
Auto BW
Min BW
Current Collected BW:
Interfaces Protected:
VPN Bind Type
VPN Bind Value
Car Policy
Tunnel Group
Primary Tunnel
Backup Tunnel
Group Status
Execute the display mpls te cspf tedb all command on Router A to view information about
links in TEDB.
[RouterA] display mpls te cspf tedb all
Maximum Node Supported: 128
Current Total Node Number: 4
Id
1
2
3
4
8. Create a static route to direct traffic to the MPLS TE tunnel
[RouterA] ip route-static 30.1.1.2 24 tunnel 1 preference 1
Execute the display ip routing-table command on Router A. You can see a static route entry
with interface Tunnel 1 as the outgoing interface.
Inter-AS MPLS TE tunnel using RSVP-TE Configuration
example
Network requirements
Router A and Router B are in AS 100, and they run OSPF as the IGP. Router C and Router D are in
AS 200, and they run OSPF as the IGP.
Establish an EBGP connection between ASBRs Router B and Router C. Redistribute BGP routes
into OSPF and OSPF routes into BGP, so that a route is available between AS 100 and AS 200.
Establish an MPLS TE tunnel between Router A and Router D by using RSVP-TE, with the
bandwidth being 2000 kbps. Along the tunnel, set the maximum link bandwidth to 10000 kbps and
maximum reservable bandwidth to 5000 kbps.
:
:
:
:
:
:
:
:
:
:
:
:
:
:
MPLS LSR-Id IGP
3.3.3.9 ISIS
2.2.2.9 ISIS
4.4.4.9 ISIS
1.1.1.9 ISIS
Disabled
10 Retry Interval:
Disabled Reopt Freq
None
-
Disabled Auto BW Freq :
- Max BW
-
-
NONE
-
Disabled
Primary
-
-
-
Maximum Link Supported: 256
Current Total Link Number: 6
Process-Id Area
1 Level-2
1 Level-2
1 Level-2
1 Level-2
92
10 sec
: -
-
: -
Link-Count
2
2
1
1