HP HSR6800 Configuration Manual page 295

Perform the following configuration tasks on MCE. Configurations on the PE are similar to those on
the PE in common MPLS L3VPN network solutions (see
and a CE").
Configuring static routing between MCE and PE
Step
1. Enter system view.
2. Configure a static route
for a VPN instance.
3. Configure the default
precedence for static
routes.
Configuring RIP between MCE and PE
Step
1. Enter system view.
2. Create a RIP process
for a VPN instance and
enter RIP view.
3. Enable RIP on the
interface attached to
the specified network.
4. Redistribute the VPN
routes.
5. Configure the default
cost value for the
redistributed routes.
For more information about RIP, see Layer 3—IP Routing Configuration Guide.
Configuring OSPF between MCE and PE
Step
1. Enter system view.
2. Create an OSPF process for
a VPN instance and enter
OSPF view.
Command
system-view
•
ip route-static dest-address { mask |
mask-length } { gateway-address | interface-type
interface-number [ gateway-address ] |
vpn-instance d-vpn-instance-name
gateway-address } [ preference
preference-value ] [ tag tag-value ] [ description
description-text ]
•
ip route-static vpn-instance
s-vpn-instance-name&<1-6> dest-address
{ mask | mask-length } { gateway-address
[ public ] | interface-type interface-number
[ gateway-address ] | vpn-instance
d-vpn-instance-name gateway-address }
[ preference preference-value ] [ tag tag-value ]
[ description description-text ]
ip route-static default-preference
default-preference-value
Command
system-view
rip [ process-id ] vpn-instance
vpn-instance-name
network network-address
import-route protocol [ process-id ]
[ allow-ibgp ] [ cost cost | route-policy
route-policy-name | tag tag ] *
default cost value
Command
system-view
ospf [ process-id | router-id
router-id | vpn-instance
vpn-instance-name ] *
287
"Configuring static routing between a PE
Remarks
N/A
N/A
By default, RIP is disabled
on an interface.
By default, no route of any
other routing protocol is
redistributed into RIP.
Optional.
0 by default.
Remarks
N/A
N/A
Remarks
N/A
Use either
command as
needed.
Optional.
60 by default.