Configuring Mpls L3Vpns Using Ibgp Between A Pe And A Ce - HP HSR6800 Configuration Manual

PING 10.4.1.1: 56
Request time out
Request time out
Request time out
Request time out
Request time out
--- 10.4.1.1 ping statistics ---
5 packet(s) transmitted
0 packet(s) received
100.00% packet loss
Configuring MPLS L3VPNs using IBGP between a PE and a
CE
Network requirements
CE 1 and CE 3 belong to VPN 1. CE 2 and CE 4 belong to VPN 2.
VPN 1 uses route target attribute 111:1. VPN 2 uses route target attribute 222:2. Users of different
VPNs cannot access each other.
IBGP is used to exchange VPN routing information between CE and PE.
PEs use OSPF to communicate with each other and use MP-IBGP to exchange VPN routing
information.
Figure 87 Network diagram
Device
PE 1
CE 1
CE 2
data bytes, press CTRL_C to break
Interface IP address
Loop0 1.1.1.9/32
GE2/1/1 10.1.1.2/24
GE2/1/2 10.2.1.2/24
POS5/1/1 172.1.1.1/24
Loop0 4.4.4.9/32
GE2/1/1 10.1.1.1/24
Loop0 5.5.5.9/32
Device Interface
PE 2 Loop0
GE2/1/1
GE2/1/2
POS5/1/1
P Loop0
POS5/1/1
POS5/1/2/2
302
IP address
3.3.3.9/32
10.3.1.2/24
10.4.1.2/24
172.2.1.2/24
2.2.2.9/32
172.1.1.2/24
172.2.1.1/24