Configuring Kompella Mpls L2Vpn; Configuring Bgp L2Vpn Capability; Creating And Configuring An Mpls L2Vpn - HP HSR6800 Configuration Manual

Step
11. Display information about
one or all service instances
configured on the interface.
To ensure normal forwarding of VPN traffic, the Layer 2 Ethernet interface must allow the VLANs that
might appear in the VPN traffic. For more information about VLAN configuration, see Layer 2—LAN
Switching Configuration Guide.

Configuring Kompella MPLS L2VPN

To configure a Kompella MPLS L2VPN, perform the following configurations on PEs:
•
Configure BGP L2VPN capability. (Not needed for a local connection.)
•
Create and configure MPLS L2VPN.
•
Create a CE connection.

Configuring BGP L2VPN capability

Step
1. Enter system view.
2. Enter BGP view.
3. Establish the peer
relationship with the peer
PE.
4. Specify the interface for the
TCP connection.
5. Enter BGP L2VPN address
family view.
6. Enable the filtering by the
route target extended
community attributes for the
received routing information.
7. Enable the specified peer or
peers to exchange BGP
routing information for the
BGP-L2VPN address family.
For more information about the configuration in BGP-L2VPN address family, see "Configuring MPLS
L3VPN."

Creating and configuring an MPLS L2VPN

Step
1. Enter system view.
Command
display service-instance
interface interface-type
interface-number
[ service-instance instance-id ] [ |
{ begin | exclude | include }
regular-expression ]
Command
system-view
bgp as-number
peer { group-name | ip-address }
as-number as-number
peer { group-name | ip-address }
connect-interface interface-type
interface-number
l2vpn-family
policy vpn-target
peer { group-name | ip-address }
enable
Command
system-view
164
Remarks
Available in any view.
Remarks
N/A
N/A
N/A
N/A
N/A
Optional.
Enabled by default.
N/A
Remarks
N/A