HP HSR6800 Configuration Manual page 407

Step
1. Enter system view.
2. Create a RIPng process for
an IPv6 VPN instance and
enter RIPng view.
3. Redistribute the VPN routes.
4. Configure the default cost
value for the redistributed
routes.
5. Return to system view.
6. Enter interface view.
7. Enable the RIPng process
on the interface.
For more information about RIPng, see Layer 3—IP Routing Configuration Guide.
Configuring OSPFv3 between an MCE and a PE
Step
1. Enter system view.
2. Create an OSPFv3 process
for an IPv6 VPN instance
and enter OSPFv3 view.
3. Set the router ID.
4. Redistribute the VPN routes.
5. Configure a filtering policy to
filter the redistributed routes.
6. Return to system view.
7. Enter interface view.
8. Enable the OSPFv3 process
on the interface.
For more information about OSPFv3, see Layer 3—IP Routing Configuration Guide.
Configuring IPv6 IS-IS between an MCE and a PE
Step
1. Enter system view.
Command
system-view
ripng [ process-id ] vpn-instance
vpn-instance-name
import-route protocol
[ process-id ] [ allow-ibgp ] [ cost
cost | route-policy
route-policy-name ] *
default cost value
quit
interface interface-type
interface-number
ripng process-id enable
Command
system-view
ospfv3 [ process-id ]
vpn-instance vpn-instance-name
router-id router-id
import-route protocol
[ process-id | allow-ibgp ] [ cost
value | route-policy
route-policy-name | type type ] *
filter-policy { acl6-number |
ipv6-prefix ipv6-prefix-name }
export [ bgp4+ | direct | isisv6
process-id | ospfv3 process-id |
ripng process-id | static ]
quit
interface interface-type
interface-number
ospfv3 process-id area area-id
[ instance instance-id ]
Command
system-view
399
Remarks
N/A
N/A
By default, no route of any other
routing protocol is redistributed
into RIPng.
Optional.
0 by default.
N/A
N/A
Disabled by default.
Remarks
N/A
N/A
N/A
By default, no route of any other
routing protocol is redistributed
into OSPFv3.
Optional.
By default, redistributed routes
are not filtered.
N/A
N/A
Disabled by default.
Remarks
N/A