Configuring Svc Mpls L2Vpn - HP HSR6800 Configuration Manual

•
On the two PEs of the connection, use the ccc interface in-label out-label command to
specify the incoming and the outgoing labels, and other information as needed. You do not
need to configure two static LSPs (with the static-lsp command) for each remote CCC
connection.
•
On each P device between the two PEs, use the static-lsp command to configure a static LSP
for both directions of the CCC connection.
Configuring a PE
Follow these guidelines when you configure a remote CCC connection on a PE:
•
The label range for CCC is 16 to 1023, which is the label range for static LSPs.
•
Only when the link that the outgoing interface connects is a point-to-point link, can you use the
out-interface keyword to specify the outgoing interface. If the link is not a point-to-point link but,
for example, a link connecting to Layer 3 Ethernet interface, VLAN interface, or Layer 3
aggregate interface, you must use the nexthop keyword to specify the IP address of the next
hop.
•
In CCC mode, if the PE-CE interface of a PE is an Ethernet subinterface, all packets sent from
the PE to the CE carry a VLAN tag. You must configure the PE-CE interface of the CE to permit
the packets that carry that VLAN tag.
To configure a PE:
Step
1. Enter system view.
2. Create a remote
CCC connection.
Configuring a P device
Step
1. Enter system view.
2. Configure a transit static
LSP.

Configuring SVC MPLS L2VPN

You can configure an ordinary static VC (SVC) or configure a pair of primary and backup SVCs in the
following methods:
•
Configure a static VC on a Layer 3 interface. This method does not support VC redundancy.
•
Configure a primary static VC and a backup static VC on a Layer 3 interface. This method
implements VC redundancy.
•
Configure a primary static VC and a backup static VC for a service instance. This method
implements VC redundancy.
Command
system-view
ccc ccc-connection-name interface
interface-type interface-number in-label
in-label-value out-label out-label-value
{ nexthop ip-address | out-interface
interface-type interface-number }
[ control-word | no-control-word ]
Command
system-view
static-lsp transit lsp-name incoming-interface
interface-type interface-number in-label in-label
{ nexthop next-hop-addr | outgoing-interface
interface-type interface-number } out-label
out-label
158
Remarks
N/A
The interface interface-type
interface-number option
specifies a PE-CE interface of
the PE. By specifying the
interface, you bind the AC link
on the interface to the remote
CCC connection to be created.
Remarks
N/A
For more
information about
the static-lsp
command, see
MPLS Command
Reference.