HP HSR6800 Configuration Manual page 441

Figure 110 Network diagram
VPN 1
2012:1::/64
2012:1::2/64
Configuration procedure
Assume that the system name of the MCE device is MCE, the system names of the edge routers of
VPN 1 and VPN 2 are VR1 and VR2, respectively, and the system name of PE 1 is PE1.
1. Configure VPN instances on the MCE and PE 1:
# On MCE, configure VPN instances vpn1 and vpn2, and specify an RD and route targets for
each VPN instance.
<MCE> system-view
[MCE] ip vpn-instance vpn1
[MCE-vpn-instance-vpn1] route-distinguisher 10:1
[MCE-vpn-instance-vpn1] vpn-target 10:1
[MCE-vpn-instance-vpn1] quit
[MCE] ip vpn-instance vpn2
[MCE-vpn-instance-vpn2] route-distinguisher 20:1
[MCE-vpn-instance-vpn2] vpn-target 20:1
[MCE-vpn-instance-vpn2] quit
# Bind interface GigabitEthernet 2/1/1 with VPN instance vpn1 and configure an IPv6 address
for the interface.
[MCE] interface gigabitethernet 2/1/1
[MCE-GigabitEthernet2/1/1] ip binding vpn-instance vpn1
[MCE-GigabitEthernet2/1/1] ipv6 address 2001:1::1 64
[MCE-GigabitEthernet2/1/1] quit
# Bind interface GigabitEthernet 2/1/2 with VPN instance vpn2, and configure an IPv6 address
for the interface.
GE2/1/1
2001:1::2/96
GE2/1/1
GE2/1/2
2001:1::1/64
VR 1
GE2/1/1
2002:1::2/64
GE2/1/2
2012::2/64
PE 1
GE2/1/1.2
GE2/1/1.1
GE2/1/3.2
GE2/1/3.1
MCE
GE2/1/2
2002:1::1/64
VR 2
VPN 2
2012::/64
433
VPN 2
Site 1
CE
PE 2
PE 3
CE
VPN 1
Site 2