HP HSR6800 Configuration Manual page 313

[P-POS5/1/1] mpls ldp
[P-POS5/1/1] quit
[P] interface pos 5/1/2
[P-POS5/1/2] mpls
[P-POS5/1/2] mpls ldp
[P-POS5/1/2] quit
# Configure PE 2.
[PE2] mpls lsr-id 3.3.3.9
[PE2] mpls
[PE2-mpls] quit
[PE2] mpls ldp
[PE2-mpls-ldp] quit
[PE2] interface pos 5/1/1
[PE2-POS5/1/1] mpls
[PE2-POS5/1/1] mpls ldp
[PE2-POS5/1/1] quit
After the configurations, P establishes an LDP session with PE 1 and PE 2 respectively.
Execute the display mpls ldp session command. The output shows that the session status is
Operational. Execute the display mpls ldp lsp command. The output shows the LSPs
established by LDP. Take PE 1 as an example:
[PE1] display mpls ldp session
Total number of sessions: 1
----------------------------------------------------------------
Peer-ID
---------------------------------------------------------------
2.2.2.9:0
---------------------------------------------------------------
LAM : Label Advertisement Mode
[PE1] display mpls ldp lsp
------------------------------------------------------------------
SN DestAddress/Mask
------------------------------------------------------------------
1 1.1.1.9/32
2 2.2.2.9/32
3 3.3.3.9/32
------------------------------------------------------------------
A '*' before an LSP means the LSP is not established
A '*' before a Label means the USCB or DSCB is stale
3. Configure VPN instances on PEs to allow CEs to access:
# Configure PE 1.
[PE1] ip vpn-instance vpn1
[PE1-vpn-instance-vpn1] route-distinguisher 100:1
[PE1-vpn-instance-vpn1] vpn-target 111:1
[PE1-vpn-instance-vpn1] quit
[PE1] ip vpn-instance vpn2
[PE1-vpn-instance-vpn2] route-distinguisher 100:2
[PE1-vpn-instance-vpn2] vpn-target 222:2
LDP Session(s) in Public Network
Status LAM
Operational DU
LDP LSP Information
In/OutLabel
3/NULL
NULL/3
NULL/1024
305
SsnRole FT MD5
Passive Off Off
FT : Fault Tolerance
Next-Hop In/Out-Interface
127.0.0.1 -------/InLoop0
172.1.1.2 -------/POS5/1/1
172.1.1.2 -------/POS5/1/1
KA-Sent/Rcv
5/5