Example For Configuring Svc Mpls L2Vpn With The Vc Type Of Ppp - HP HSR6800 Configuration Manual

# Configure the link protocol as PPP on interface POS 5/1/0 (the interface connected to PE 2),
and configure an IP address for the interface.
<Sysname> system-view
[Sysname] sysname CE2
[CE2] interface pos 5/1/0
[CE2-POS5/1/0] link-protocol ppp
[CE2-POS5/1/0] ip address 100.1.1.2 24
Verifying the configuration:
# Display CCC connection information on PE 1. The output shows that a remote CCC
connection has been established.
[PE1] display ccc
Total
Local
Remote ccc vc
***Name
Type
State
Intf
In-label
Out-label
Out-interface
# Ping CE 2 from CE 1. The output shows that CE 1 and CE 2 can ping each other.
[CE1] ping 100.1.1.2
PING 100.1.1.2: 56
Reply from 100.1.1.2: bytes=56 Sequence=1 ttl=255 time=180 ms
Reply from 100.1.1.2: bytes=56 Sequence=2 ttl=255 time=60 ms
Reply from 100.1.1.2: bytes=56 Sequence=3 ttl=255 time=10 ms
Reply from 100.1.1.2: bytes=56 Sequence=4 ttl=255 time=70 ms
Reply from 100.1.1.2: bytes=56 Sequence=5 ttl=255 time=60 ms
--- 100.1.1.2 ping statistics ---
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
round-trip min/avg/max = 10/76/180 ms
Example for configuring SVC MPLS L2VPN with the VC type
of PPP
Network requirements
CEs are connected to PEs through POS interfaces. The link layer encapsulation protocol is PPP.
Establish an SVC, so CE 1 and CE 2 can exchange Layer 2 packets across the backbone.
ccc vc : 1
ccc vc : 0,
: 1,
: ce1-ce2
: remote
: up
: POS5/1/0 (up)
: 100
: 200
: POS5/1/1
data bytes, press CTRL_C to break
0 up
1 up
173