HP HSR6800 Configuration Manual page 193

[PE3-Serial2/1/0] quit
# Configure OSPF on PE 3.
[PE3] ospf
[PE3-ospf-1] area 0
[PE3-ospf-1-area-0.0.0.0] network 13.1.1.0 0.0.0.255
[PE3-ospf-1-area-0.0.0.0] network 3.3.3.3 0.0.0.0
[PE3-ospf-1-area-0.0.0.0] quit
[PE3-ospf-1] quit
# Enable L2VPN and MPLS L2VPN.
[PE3] l2vpn
[PE3-l2vpn] mpls l2vpn
[PE3-l2vpn] quit
# Create a VC on the interface connected to CE 2. This interface needs no IP address.
[PE3] interface serial 2/1/1
[PE3-Serial2/1/1] mpls l2vc 1.1.1.1 30
[PE3-Serial2/1/1] quit
5. Configure CE 2:
# Assign IP addresses to interfaces.
<Sysname> system-view
[Sysname] sysname CE2
[CE2] interface serial 2/1/0
[CE2-Serial2/1/0] link-protocol ppp
[CE2-Serial2/1/0] ip address 100.1.1.2 24
[CE2-Serial2/1/0] quit
[CE2] interface serial 2/1/1
[CE2-Serial2/1/1] link-protocol ppp
[CE2-Serial2/1/1] ip address 100.2.1.2 24
# Configure IS-IS.
[CE2] isis 1
[CE2-isis-1] network-entity 10.0000.0000.0002.00
[CE2-isis-1] quit
[CE2] interface serial 2/1/0
[CE2-Serial2/1/0] isis enable 1
[CE2-Serial2/1/0] quit
[CE2] interface serial 2/1/1
[CE2-Serial2/1/1] isis enable 1
[CE2-Serial2/1/1] quit
Verifying the configuration:
# Display VC information on PE 1. The output shows that two VCs have been established, one
up and one blocked.
<PE1> display mpls l2vc
Total ldp vc : 2
Transport
VC ID
20
30
1 up
Client
Intf
S2/1/0
S2/1/0
0 down 1 blocked
Service VC
ID State
-- up
-- blocked
185
Local Remote
VC Label VC Label
1026 1033
1027 1050