HP HSR6800 Configuration Manual page 325

[Spoke-PE1-POS5/1/1] mpls
[Spoke-PE1-POS5/1/1] mpls ldp
[Spoke-PE1-POS5/1/1] quit
# Configure Spoke-PE 2.
[Spoke-PE2] mpls lsr-id 3.3.3.9
[Spoke-PE2] mpls
[Spoke-PE2-mpls] quit
[Spoke-PE2] mpls ldp
[Spoke-PE2-mpls-ldp] quit
[Spoke-PE2] interface pos 5/1/1
[Spoke-PE2-POS5/1/1] mpls
[Spoke-PE2-POS5/1/1] mpls ldp
[Spoke-PE2-POS5/1/1] quit
# Configure the Hub-PE.
[Hub-PE] mpls lsr-id 2.2.2.9
[Hub-PE] mpls
[Hub-PE-mpls] quit
[Hub-PE] mpls ldp
[Hub-PE-mpls-ldp] quit
[Hub-PE] interface pos 5/1/1
[Hub-PE-POS5/1/1] mpls
[Hub-PE-POS5/1/1] mpls ldp
[Hub-PE-POS5/1/1] quit
[Hub-PE] interface pos 5/1/2/2
[Hub-PE-POS5/1/2] mpls
[Hub-PE-POS5/1/2] mpls ldp
[Hub-PE-POS5/1/2] quit
After the configuration, LDP sessions are established between Spoke-PE 1 and Hub-PE, and
between Spoke-PE 2 and Hub-PE. Execute the display mpls ldp session command. The
output shows that the session status is Operational. Execute the display mpls ldp lsp
command. The output shows the LSPs established by LDP.
Take Spoke-PE 1 as an example:
[Spoke-PE1] display mpls ldp session
LDP Session(s) in Public Network
Total number of sessions: 1
----------------------------------------------------------------
Peer-ID Status
---------------------------------------------------------------
2.2.2.9:0 Operational
---------------------------------------------------------------
LAM : Label Advertisement Mode
[Spoke-PE1] display mpls ldp lsp
------------------------------------------------------------------
SN DestAddress/Mask
------------------------------------------------------------------
1 1.1.1.9/32
2 2.2.2.9/32
3 3.3.3.9/32
LAM SsnRole
DU Passive
FT
LDP LSP Information
In/OutLabel Next-Hop
3/NULL 127.0.0.1
NULL/3 172.1.1.2
NULL/1024 172.1.1.2
317
FT MD5 KA-Sent/Rcv
Off Off 5/5
: Fault Tolerance
In/Out-Interface
-------/InLoop0
-------/POS5/1/1
-------/POS5/1/1