HP HSR6800 Configuration Manual page 91

[RouterB-isis-1] network-entity 00.0005.0000.0000.0002.00
[RouterB-isis-1] quit
[RouterB] interface giabitethernet 2/1/1
[RouterB-GigabitEthernet2/1/1] isis enable 1
[RouterB-GigabitEthernet2/1/1] quit
[RouterB] interface giabitethernet 2/1/2
[RouterB-GigabitEthernet2/1/2] isis enable 1
[RouterB-GigabitEthernet2/1/2] quit
[RouterB] interface loopback 0
[RouterB-LoopBack0] isis enable 1
[RouterB-LoopBack0] quit
# Configure Router C.
<RouterB> system-view
[RouterC] isis 1
[RouterC-isis-1] network-entity 00.0005.0000.0000.0003.00
[RouterC-isis-1] quit
[RouterC] interface giabitethernet 2/1/1
[RouterC-GigabitEthernet2/1/1] isis enable 1
[RouterC-GigabitEthernet2/1/1] quit
[RouterC] interface loopback 0
[RouterC-LoopBack0] isis enable 1
[RouterC-LoopBack0] quit
Execute the display ip routing-table command on each router. The output shows that all
nodes have learned the host routes of other nodes with LSR IDs as destinations. Take Router A
for example:
[RouterA] display ip routing-table
Routing Tables: Public
Destinations : 8
Destination/Mask
1.1.1.1/32
2.1.1.0/24
2.1.1.1/32
2.2.2.2/32
3.2.1.0/24
3.3.3.3/32
127.0.0.0/8
127.0.0.1/32
3. Configure basic MPLS TE:
# Configure Router A.
[RouterA] mpls lsr-id 1.1.1.1
[RouterA] mpls
[RouterA-mpls] mpls te
[RouterA-mpls] quit
[RouterA] interface giabitethernet 2/1/1
[RouterA-GigabitEthernet2/1/1] mpls
[RouterA-GigabitEthernet2/1/1] mpls te
[RouterA-GigabitEthernet2/1/1] quit
# Configure Router B.
Routes : 8
Proto Pre Cost
Direct 0 0
Direct 0 0
Direct 0 0
ISIS 15 10
ISIS 15 20
ISIS 15 20
Direct 0 0
Direct 0 0
83
NextHop Interface
127.0.0.1 InLoop0
2.1.1.1 GE2/1/1
127.0.0.1 InLoop0
2.1.1.2 GE2/1/1
2.1.1.2 GE2/1/1
2.1.1.2 GE2/1/1
127.0.0.1 InLoop0
127.0.0.1 InLoop0