HP HSR6800 Configuration Manual page 354

[PE1] interface loopback 0
[PE1-LoopBack0] isis enable 1
[PE1-LoopBack0] quit
[PE1] interface pos 5/1/2
[PE1-POS5/1/2] ip address 30.1.1.1 24
[PE1-POS5/1/2] isis enable 1
[PE1-POS5/1/2] mpls
[PE1-POS5/1/2] mpls ldp
[PE1-POS5/1/2] mpls ldp transport-address interface
[PE1-POS5/1/2] quit
[PE1] bgp 100
[PE1-bgp] peer 4.4.4.9 as-number 100
[PE1-bgp] peer 4.4.4.9 connect-interface loopback 0
[PE1-bgp] ipv4-family vpnv4
[PE1-bgp-af-vpnv4] peer 4.4.4.9 enable
[PE1-bgp-af-vpnv4] quit
[PE1-bgp] quit
# Configure PE 2 in a similar way to configuring PE 1. (Details not shown.)
After completing the configurations, execute commands display mpls ldp session, display
bgp peer and display isis peer respectively on either PE 1 or PE 2. The output shows that the
LDP session is established, the BGP peer relationship is established and in the Established
state, and the IS-IS neighbor relationship is established and up.
Take PE 1 as an example.
[PE1] display mpls ldp session
Total number of sessions: 1
----------------------------------------------------------------
Peer-ID
----------------------------------------------------------------
4.4.4.9:0
----------------------------------------------------------------
LAM : Label Advertisement Mode
[PE1] display bgp peer
BGP local router ID : 3.3.3.9
Local AS number : 100
Total number of peers : 1
Peer
4.4.4.9
[PE1] display isis peer
System Id
0000.0000.0005 POS5/1/2
2. Configure the customer VPN—enable IS-IS and enable LDP between PE 3 and CE 1, and
between PE 4 and CE 2:
# Configure PE 3.
<PE3> system-view
[PE3] interface loopback 0
[PE3-LoopBack0] ip address 1.1.1.9 32
LDP Session(s) in Public Network
Status LAM
Operational DU
AS MsgRcvd MsgSent
100 162 145
Peer information for ISIS(1)
----------------------------
Interface Circuit Id
346
SsnRole FT MD5
Active Off Off
FT : Fault Tolerance
Peers in established state : 1
OutQ PrefRcv
0 0
State HoldTime Type
001 Up 29s
KA-Sent/Rcv
378/378
Up/Down State
02:12:47 Established
PRI
L1L2 --