HP HSR6800 Configuration Manual page 312

[PE2-ospf-1-area-0.0.0.0] network 3.3.3.9 0.0.0.0
[PE2-ospf-1-area-0.0.0.0] quit
[PE2-ospf-1] quit
After the configurations, P establishes an OSPF adjacency with PE 1 and PE 2 respectively.
Execute the display ospf peer command. The output shows that the adjacency status is Full.
Execute the display ip routing-table command. The output shows that the PEs have learned
the routes to the loopback interfaces of each other. Take PE 1 as an example:
[PE1] display ip routing-table
Routing Tables: Public
Destinations : 8
Destination/Mask
1.1.1.9/32
2.2.2.9/32
3.3.3.9/32
127.0.0.0/8
127.0.0.1/32
172.1.1.0/24
172.1.1.1/32
172.2.1.0/24
[PE1] display ospf peer verbose
OSPF Process 1 with Router ID 1.1.1.9
Area 0.0.0.0 interface 172.1.1.1(POS5/1/1)'s neighbors
Router ID: 2.2.2.9
State: Full
DR: 172.1.1.1
Dead timer due in 38
Neighbor is up for 00:02:44
Authentication Sequence: [ 0 ]
Neighbor state change count: 5
2. Configure basic MPLS and MPLS LDP on the MPLS backbone to establish LDP LSPs:
# Configure PE 1.
[PE1] mpls lsr-id 1.1.1.9
[PE1] mpls
[PE1-mpls] quit
[PE1] mpls ldp
[PE1-mpls-ldp] quit
[PE1] interface pos 5/1/1
[PE1-POS5/1/1] mpls
[PE1-POS5/1/1] mpls ldp
[PE1-POS5/1/1] quit
# Configure the P router.
[P] mpls lsr-id 2.2.2.9
[P] mpls
[P-mpls] quit
[P] mpls ldp
[P-mpls-ldp] quit
[P] interface pos 5/1/1
[P-POS5/1/1] mpls
Routes : 8
Proto Pre Cost
Direct 0 0
OSPF 10 1
OSPF 10 2
Direct 0 0
Direct 0 0
Direct 0 0
Direct 0 0
OSPF 10 1
Neighbors
Address: 172.1.1.2
Mode:Nbr is Master
BDR: 172.1.1.2 MTU: 0
sec
304
NextHop Interface
127.0.0.1 InLoop0
172.1.1.2 POS5/1/1
172.1.1.2 POS5/1/1
127.0.0.1 InLoop0
127.0.0.1 InLoop0
172.1.1.1 POS5/1/1
127.0.0.1 InLoop0
172.1.1.2 POS5/1/1
GR State: Normal
Priority: 1