HP HSR6800 Configuration Manual page 424

[PE1-POS5/1/1] mpls ldp
[PE1-POS5/1/1] quit
# Configure basic MPLS on ASBR-PE 1 and enable MPLS LDP for both ASBR-PE 1 and the
interface connected to PE 1.
<ASBR-PE1> system-view
[ASBR-PE1] mpls lsr-id 2.2.2.9
[ASBR-PE1] mpls
[ASBR-PE1-mpls] quit
[ASBR-PE1] mpls ldp
[ASBR-PE1-mpls-ldp] quit
[ASBR-PE1] interface pos 5/1/1
[ASBR-PE1-POS5/1/1] mpls
[ASBR-PE1-POS5/1/1] mpls ldp
[ASBR-PE1-POS5/1/1] quit
# Configure basic MPLS on ASBR-PE 2 and enable MPLS LDP for both ASBR-PE 2 and the
interface connected to PE 2.
<ASBR-PE2> system-view
[ASBR-PE2] mpls lsr-id 3.3.3.9
[ASBR-PE2] mpls
[ASBR-PE2-mpls] quit
[ASBR-PE2] mpls ldp
[ASBR-PE2-mpls-ldp] quit
[ASBR-PE2] interface pos 5/1/1
[ASBR-PE2-POS5/1/1] mpls
[ASBR-PE2-POS5/1/1] mpls ldp
[ASBR-PE2-POS5/1/1] quit
# Configure basic MPLS on PE 2 and enable MPLS LDP for both PE 2 and the interface
connected to ASBR-PE 2.
<PE2> system-view
[PE2] mpls lsr-id 4.4.4.9
[PE2] mpls
[PE2-mpls] quit
[PE2] mpls ldp
[PE2-mpls-ldp] quit
[PE2] interface pos 5/1/1
[PE2-POS5/1/1] mpls
[PE2-POS5/1/1] mpls ldp
[PE2-POS5/1/1] quit
After the configurations, each PE and the ASBR PE in the same AS can establish the LDP
neighbor relationship. Execute the display mpls ldp session command on the routers. The
output shows that the session status is Operational.
3. Configure a VPN instance on the PEs:
For the same VPN, the route targets for the VPN instance on the PE must match those for the
VPN instance on the ASBR-PE in the same AS. This is not required for PEs in different ASs.
# Configure CE 1.
<CE1> system-view
[CE1] interface gigabitethernet 2/1/1
[CE1-GigabitEthernet2/1/1] ipv6 address 2001:1::1 96
[CE1-GigabitEthernet2/1/1] quit
416