Configuring Mce - HP HSR6800 Configuration Manual

Configuring MCE

Network requirements
As shown in
VPNs and advertise the VPN routes to PE 1 through OSPF.
Figure 98 Network diagram
VPN 1
192.168.0.0
192.168.0.1/24
Configuration procedure
Assume that the system name of the MCE device is MCE, the system names of the edge routers of
VPN 1 and VPN 2 are VR1 and VR2, respectively, and the system name of PE 1 is PE1.
1. Configure VPN instances on the MCE and PE 1:
# On the MCE, configure VPN instances vpn1 and vpn2, and specify an RD and route targets
for each VPN instance.
<MCE> system-view
[MCE] ip vpn-instance vpn1
[MCE-vpn-instance-vpn1] route-distinguisher 10:1
[MCE-vpn-instance-vpn1] vpn-target 10:1
[MCE-vpn-instance-vpn1] quit
[MCE] ip vpn-instance vpn2
[MCE-vpn-instance-vpn2] route-distinguisher 20:1
[MCE-vpn-instance-vpn2] vpn-target 20:1
[MCE-vpn-instance-vpn2] quit
Figure 98, VPN 2 runs RIP. Configure the MCE device to separate routes from different
GE3/1/2
10.214.10.2/24
GE3/1/1
10.214.10.3/24
VR 1
192.168.10.1/24
PE 1
GE3/1/3.1
20.1.1.1/24
GE3/1/1.1
20.1.1.2/24
GE3/1/1.2
MCE
30.1.1.2/24
GE3/1/3.2
30.1.1.1/24
GE3/1/1
GE3/1/2
10.214.20.3/24
GE3/1/1
10.214.20.2/24
VR 2
GE3/1/2
VPN 2
192.168.10.0
367
VPN 2
Site 1
CE
PE 2
PE 3
CE
VPN 1
Site 2