HP HSR6800 Configuration Manual page 105
Hide thumbs
Also See for HSR6800:
- Command reference manual (170 pages) ,
- Installation manual (146 pages) ,
- Configuration manual (95 pages)
Table of Contents
Advertisement
[RouterD-ospf-1] area 0
[RouterD-ospf-1-area-0.0.0.0] mpls-te enable
[RouterD-ospf-1-area-0.0.0.0] quit
[RouterD-ospf-1] quit
6.
Configure a loose explicit route:
# Configure a loose explicit route on Router A.
[RouterA] explicit-path atod enable
[RouterA-explicit-path-atod] next hop 10.1.1.2 include loose
[RouterA-explicit-path-atod] next hop 20.1.1.2 include loose
[RouterA-explicit-path-atod] next hop 30.1.1.2 include loose
[RouterA-explicit-path-atod] quit
7.
Configure MPLS TE attributes of links:
# Configure the maximum link bandwidth and maximum reservable bandwidth on Router A.
[RouterA] interface giabitethernet 2/1/1
[RouterA-GigabitEthernet2/1/1] mpls te max-link-bandwidth 10000
[RouterA-GigabitEthernet2/1/1] mpls te max-reservable-bandwidth 5000
[RouterA-GigabitEthernet2/1/1] quit
# Configure the maximum link bandwidth and maximum reservable bandwidth on Router B.
[RouterB] interface giabitethernet 2/1/1
[RouterB-GigabitEthernet2/1/1] mpls te max-link-bandwidth 10000
[RouterB-GigabitEthernet2/1/1] mpls te max-reservable-bandwidth 5000
[RouterB-GigabitEthernet2/1/1] quit
[RouterB] interface pos 5/1/0
[RouterB-POS5/1/0] mpls te max-link-bandwidth 10000
[RouterB-POS5/1/0] mpls te max-reservable-bandwidth 5000
[RouterB-POS5/1/0] quit
# Configure the maximum link bandwidth and maximum reservable bandwidth on Router C.
[RouterC] interface giabitethernet 2/1/1
[RouterC-GigabitEthernet2/1/1] mpls te max-link-bandwidth 10000
[RouterC-GigabitEthernet2/1/1] mpls te max-reservable-bandwidth 5000
[RouterC-GigabitEthernet2/1/1] quit
[RouterC] interface pos 5/1/0
[RouterC-POS5/1/0] mpls te max-link-bandwidth 10000
[RouterC-POS5/1/0] mpls te max-reservable-bandwidth 5000
[RouterC-POS5/1/0] quit
# Configure the maximum link bandwidth and maximum reservable bandwidth on Router D.
[RouterD] interface giabitethernet 2/1/1
[RouterD-GigabitEthernet2/1/1] mpls te max-link-bandwidth 10000
[RouterD-GigabitEthernet2/1/1] mpls te max-reservable-bandwidth 5000
[RouterD-GigabitEthernet2/1/1] quit
8.
Create an MPLS TE tunnel:
# Create an MPLS TE tunnel on Router A.
[RouterA] interface tunnel 1
[RouterA-Tunnel1] ip address 7.1.1.1 255.255.255.0
[RouterA-Tunnel1] tunnel-protocol mpls te
[RouterA-Tunnel1] destination 4.4.4.9
[RouterA-Tunnel1] mpls te tunnel-id 10
97
Advertisement
Table of Contents
Troubleshooting
