Command And Hardware Compatibility; Configuring Ppp; Ppp Configuration Task List; Enabling Ppp Encapsulation On An Interface - HP MSR Router Series Wan Access Configuration Manual

Command and hardware compatibility

Commands and descriptions for centralized devices apply to the following routers:
• MSR1002-4/1003-8S.
MSR2003.
•
MSR2004-24/2004-48.
•
MSR3012/3024/3044/3064.
•
Commands and descriptions for distributed devices apply to MSR4060 and MSR4080 routers.

Configuring PPP

PPP configuration task list

Tasks at a glance
(Required.)
(Optional.)
(Optional.)
(Optional.)
(Optional.)
(Optional.)
(Optional.)
(Optional.)

Enabling PPP encapsulation on an interface

Step
1. Enter system view.
2. Enter interface view.
3. Enable PPP encapsulation on
the interface.

Configuring PPP authentication

You can configure several authentication modes simultaneously. In LCP negotiation, the authenticator
negotiates with the peer in the sequence of configured authentication modes until the LCP negotiation
succeeds. If the response packet from the peer carries a recommended authentication mode, the
authenticator directly uses the authentication mode if it finds the mode configured.
Enabling PPP encapsulation on an interface
Configuring PPP authentication
Configuring the polling feature
Configuring PPP negotiation
Enabling IP header compression
Enabling PPP link quality monitoring
Enabling PPP accounting
Configuring the nas-port-type attribute
Command
system-view
interface interface-type
interface-number
link-protocol ppp
5
Remarks
N/A
N/A
By default, all interfaces except
Ethernet interfaces, VLAN
interfaces, and ATM interfaces use
PPP as the link layer protocol.