HP HSR6800 Configuration Manual page 136

7. Verify the configuration:
# Execute the display interface tunnel command on Router A. You can see that the tunnel
interface is up.
[RouterA] display interface tunnel
Tunnel1 current state: UP
Line protocol current state: UP
Description: Tunnel1 Interface
The Maximum Transmit Unit is 64000
Internet Address is 7.1.1.1/24 Primary
Encapsulation is TUNNEL, service-loopback-group ID not set
Tunnel source unknown, destination 4.4.4.9
Tunnel protocol/transport CR_LSP
Output queue : (Urgent queuing : Size/Length/Discards)
Output queue : (Protocol queuing : Size/Length/Discards)
Output queue : (FIFO queuing : Size/Length/Discards)
Last 300 seconds input:
Last 300 seconds output:
0 packets input,
0 input error
0 packets output,
0 output error
# Execute the display mpls te tunnel-interface command on Router A to view detailed
information about the tunnel.
[RouterA] display mpls te tunnel-interface
Tunnel Name
Tunnel Desc
Tunnel State Desc :
Tunnel Attributes :
LSP ID
Session ID
Admin State
Ingress LSR ID
Signaling Prot
Class Type
Reserved BW
Setup Priority
Affinity Prop/Mask
Explicit Path Name
Tie-Breaking Policy :
Metric Type
Record Route
FRR Flag
BackUpBW Type
Route Pinning
Retry Limit
Reopt
Back Up Type
Back Up LSPID
Auto BW
0 bytes/sec, 0 packets/sec
0 bytes/sec, 0 packets/sec
0 bytes
0 bytes
: Tunnel1
: Tunnel1 Interface
CR-LSP is Up
: 1.1.1.9:3
: 10
: UP
: 1.1.1.9
: RSVP
: CT2
: 4000 kbps
: 0
: 0x0/0x0
: -
None
: None
: Disabled
: Disabled
: -
: Disabled
: 10
: Disabled
: None
: -
: Disabled
128
0/100/0
0/75/0
Oper State
Egress LSR ID:
Resv Style
Tunnel BW
Hold Priority:
Record Label : Disabled
BackUpBW Flag: Not Supported
BackUpBW : -
Retry Interval: 10 sec
Reopt Freq : -
Auto BW Freq : -
0/500/0
: UP
4.4.4.9
: SE
: 4000 kbps
0