HP HSR6800 Configuration Manual page 125

Tunnel Attributes
LSP ID
Session ID
Admin State
Ingress LSR ID
Signaling Prot
Class Type
Reserved BW
Setup Priority
Affinity Prop/Mask
Explicit Path Name
Tie-Breaking Policy :
Metric Type
Record Route
FRR Flag
BackUpBW Type
Route Pinning
Retry Limit
Reopt
Back Up Type
Back Up LSPID
Auto BW
Min BW
Current Collected BW:
Interfaces Protected:
VPN Bind Type
VPN Bind Value
Car Policy
Tunnel Group
Primary Tunnel
Backup Tunnel
Group Status
5. Configure a bypass tunnel on Router B (the PLR):
# Create an explicit path for the bypass LSP.
[RouterB] explicit-path by-path
[RouterB-explicit-path-by-path] next hop 3.2.1.2
[RouterB-explicit-path-by-path] next hop 3.3.1.2
[RouterB-explicit-path-by-path] next hop 3.3.3.3
[RouterB-explicit-path-by-path] quit
# Create the bypass tunnel.
[RouterB] interface tunnel 5
[RouterB-Tunnel5] ip address 11.1.1.1 255.255.255.0
[RouterB-Tunnel5] tunnel-protocol mpls te
[RouterB-Tunnel5] destination 3.3.3.3
[RouterB-Tunnel5] mpls te tunnel-id 15
[RouterB-Tunnel5] mpls te path explicit-path by-path preference 1
# Configure the bandwidth that the bypass tunnel protects.
[RouterB-Tunnel5] mpls te backup bandwidth 10000
:
: 1.1.1.1:1
: 10
: UP
: 1.1.1.1
: RSVP
: CT0
: 0 kbps
: 7
: 0x0/0x0
: pri-path
None
: None
: Enabled Record Label :
: Enabled BackUpBW Flag:
: - BackUpBW
: Disabled
: 10
: Disabled
: None
: -
: Disabled
: -
-
-
: NONE
: -
: Disabled
: Primary
: -
: -
: -
117
Oper State : UP
Egress LSR ID: 4.4.4.4
Resv Style : SE
Tunnel BW : 0 kbps
Hold Priority: 7
Enabled
Not Supported
: -
Retry Interval: 10 sec
Reopt Freq : -
Auto BW Freq : -
Max BW : -