Changing The Meaning Of The Ports Leds; Troubleshooting - Paradyne 8779 User Manual

Changing the Meaning of the PORTS LEDs

The LEDs for PORTS on the front panel represent the status of the DSL network
or DTE ports, depending on the Port LEDs configuration option. The LED display
can also be selected at any time through the Control branch.
Procedure
To change the meaning of the LEDs for PORTS using the Control branch:

Troubleshooting

The termination unit is designed to provide many years of trouble-free service. If a
problem occurs, however, refer to
solutions. If an error message is displayed under Health and Status on the System
and Test Status screen, refer to
recommended action.
Table 7-6.
8700-A2-GB20-40
1. From the Main Menu, select Control .
2. Move the cursor to the Port LEDs entry.
3. Toggle the selection using the spacebar.
4. Press Enter.
Troubleshooting (1 of 2)
Symptom Possible Cause
Alarm LED is on. A system failure has
occurred.
Cannot access the unit The terminal is not set up for
via the ATI. the correct rate or data
format, or the unit is
configured so it prevents
access.
Device Fail appears on The unit detects an internal
the System and Test hardware failure.
Status screen under
Self-Test results.
Power-On Self-Test The unit has detected an
fails. Only Alarm LED internal hardware failure.
is on after power-on.
No power, or the LEDs The unit is not properly
are not lit. seated in the DSLAM.
There is no power to the
DSLAM.
May 2002
7. Monitoring and Troubleshooting
Table 7-6, Troubleshooting, for possible
Table 7-1, Health and Status
Solutions
Refer to
Status
recommended action.
T
Check the cable and
connections.
T
Ensure that the unit is
configured properly in the
DSLAM. Verify its IP
address.
T
Reset the unit.
T
Reset the unit.
T
Contact your service
representative.
Verify that the unit is properly
inserted.
Verify that the DSLAM has
power.
Messages, for the
Table 7-1, Health and
Messages, for
7-25