Paradyne 8779 User Manual page 131

Table A-15. SNMP Traps Options (1 of 2)
8700-A2-GB20-40
SNMP Traps
Possible Settings: Enable, Disable
Default Setting: Disable
Controls the generation of SNMP trap messages.
Enable – SNMP trap messages are sent out to SNMP managers.
Disable – No SNMP trap messages are sent out.
Number of Trap Managers
Possible Settings: 1, 2, 3, 4, 5, 6, 7, 8, 9
Default Setting: 1
Sets the number of SNMP management systems that will receive SNMP traps.
T
Number of Trap Managers is not available when the unit is running in IP
Conservative mode.
1 – 9 – Number of trap managers. An NMS IP address is required for each manager.
NMS n IP Address
Possible Settings: 001.000.000.000 – 223.255.255.255, Clear
Default Setting: 000.000.000.000
Specifies the Internet Protocol address used to identify each SNMP trap manager.
T
NMS n IP Address is not available when the unit is running in IP Conservative
mode.
001.000.000.000 – 223.255.255.255 – Enter an address for each SNMP trap manager.
The range for the first byte is 001 to 223, with the exception of 127. The range for the
remaining three bytes is 000 to 255.
Clear – Clears the IP address and sets to all zeros.
NMS n Destination
Possible Settings: IMC, DSL1, DSL2, DSL3, DSL4, DSL5, DSL6, DSL7, DSL8
Default Setting: IMC
Provides the network destination path of each trap manager.
T
NMS n Destination is available only when the unit is configured as an NTU and not
running in IP Conservative mode. Disabled ports cannot be specified.
IMC – The Internal Management Channel (IMC) is the default network destination. This is
the management interface to the MCC card in the DSLAM.
DSL1 – DSL8 – The specified port is the network destination.
May 2002
A. Configuration Options
A-35