Paradyne 8779 User Manual page 144

B. Standards Compliance for SNMP Traps
The tests that affect the enterpriseTestStart and enterpriseTestStop traps and the
variable bindings depend on the interface. The specific tests and variable bindings
are described in the following table.
B-6
enterpriseTestStart/Stop
Interface variable bindings
T
DSL Network ifIndex (RFC 2863)
T
ifAdminStatus (RFC 2863)
T
ifOperStatus (RFC 2863)
T
ifType (RFC 2863)
T
ifTestType (RFC 2863)
The following objects control tests
in SNMP-managed devices:
– noTest(0) – Stops the test in
progress.
– testLoopLLB(4) – Initiates a
Local Loopback.
– testLoopRLB(5) – Initiates a
Repeater Loopback.
– testSendMon511(6) – Initiates a
Send and Monitor 511 test.
– testSendLLBUp(7) – Initiates an
LLB Up message to the remote
unit.
– testSendLLBDown(8) – Initiates
an LLB Down message to the
remote unit.
T
DSX-1 or ifIndex (RFC 2863)
G.703
T
ifAdminStatus (RFC 2863)
T
ifOperStatus (RFC 2863)
T
ifType (RFC 2863)
T
ifTestType (RFC 2863)
The following objects control tests
in SNMP-managed devices:
– noTest(0) – Stops the test in
progress.
– testLoopDTLB(3) – Initiates a
DTE Loopback.
– testLoopPLB(1) – A
Telco-initiated Payload
Loopback is active on the
interface (DSX-1 only).
May 2002
Possible Cause
T
enterpriseTest Start – Any one
of the following tests is active
on the interface:
– Line Loopback
– Repeater Loopback
– Remote Line Loopback
– Send and Monitor 511
T
enterpriseTest Stop – No tests
currently running on the
interface.
T
enterpriseTest Start – Any one
of the following tests is active
on the interface:
– DTE Loopback
– Telco Payload Loopback
(DSX-1 only)
T
enterpriseTest Stop – No tests
currently running on the
interface.
8700-A2-GB20-40