All Configurations; Ip Addressing Example - Paradyne 8779 User Manual

Tdm sdsl termination units
Table of Contents

Advertisement

5. IP Addressing

All Configurations

The NTU obtains its IP address when the PPP link is established over the EOC.
Use the ATI to assign:
T
T
Review the following information in preparation for selecting an IP addressing
scheme.
T
T

IP Addressing Example

Figure 5-1, Peer IP Address
network. Note that the Peer IP Address:
T
T
LTU
MCC
87xx
DSLAM
MCC Backplane
Address = 126.35.1.1
MCC Backplane
Mask = 255.255.255.0
LTU Backplane
Address = 126.35.1.16
Figure 5-1.
5-2
An IP address for each NMS. See
in Appendix A, Configuration Options .
An IP address for the TFTP server you wish to use to upload and download
configurations. See
Configuration Loader
and Configurations Using TFTP , and the documentation for your TFTP server.
Any legal host address is allowed for a given subnet. The address choice
within the subnet is arbitrary.
A single route to a subnet is all that is needed to reach every device on a
subnet. The unit's routing table supports a maximum of 20 routes.
Assignments, shows IP addressing in a typical
Refers to the IP address of the unit configured as an NTU.
Is assigned by the LTU.
Port 1
Peer IP Address = 126.35.1.32
Port 2
Peer IP Address = 126.35.1.33
Port 3
Peer IP Address = 126.35.1.34
Port 4
Peer IP Address = 126.35.1.35
Port 5
Peer IP Address = 126.35.1.36
Port 6
Peer IP Address = 126.35.1.37
Port 7
Peer IP Address = 126.35.1.38
Port 8
Peer IP Address = 126.35.1.39
Peer IP Address Assignments
May 2002
Table A-14, SNMP NMS Security Options,
in Chapter 9, Transferring Firmware
DSLAM
MCC
NTU
MCC Base
Address = 126.35.50.1
MCC Base Subnet
Mask = 255.255.255.0
79xx
NTU Backplane
Address = 126.35.50.17
79xx
79xx
79xx
79xx
79xx
79xx
99-16617
8700-A2-GB20-40

Advertisement

Table of Contents
loading

This manual is also suitable for:

U87778777

Table of Contents