Using The Asynchronous Terminal Interface; User Interface Access; Management Serial Port Settings - Paradyne 8779 User Manual

Using the Asynchronous Terminal
Interface

User Interface Access

You can communicate with the asynchronous terminal interface (ATI) using one of
the following methods:
T
T
T
Security can limit ATI access in several ways. To set up security or a login ID, refer
to

Management Serial Port Settings

Ensure that the device you connect communicates using these settings:
T
T
T
T
Refer to the installation document for your DSLAM. See
Documents
8700-A2-GB20-40
Direct connection through the Management Serial port of the DSLAM (locally
or via an external modem).
Telnet session using a Network Management System (NMS) connected to a
LAN/WAN port on the DSLAM.
Telnet session through the Embedded Operations Channel (EOC).
NOTE:
Only one asynchronous terminal interface session can be active at a time, and
another user's session cannot be forced to end. To automatically log out a
user due to inactivity, enable the Inactivity Timeout option (see
Telnet Session Options,
Chapter 6, Security
.
Data rate set to 9.6 Kbps.
Character length set to 8.
Parity set to None.
Stop Bits set to 1.
in About This Guide .
May 2002
in Appendix A, Configuration Options ).
2
Table A-12,
Product-Related
2-1