Cross-Connecting Ports; T Overview - Paradyne 8779 User Manual

Cross-Connecting Ports

Overview
Configuration of the cross-connections consists of the following steps:
This chapter describes the use of the Cross-Connect Mode and Assign Time Slots
screens. See
configuration options presented on the other screens.
Examples in this chapter show screens for DSX-1 models. The principles of
cross-connection are the same for G.703 models.
8700-A2-GB20-40
Determine how the ports will be connected and configured.
On the Network Interface Options screen, enable the DSL ports that will be in
the cross-connection if necessary. The ports are enabled by default.
On the DSX-1 or G.703 Interface Options screen, enable the DSX-1 or G.703
ports that will be in the cross-connection.
For G.703, specify whether Time Slot 16 is used for signaling (voice mode).
On the System Clock screen, configure the system clock.
On the Cross-Connect Mode screen:
— Define all DS1 Bypass ports.
— Define all DS1 Cross-Connect ports.
— Define all DS0 Cross-Connect ports.
On the Assign Time Slots screen, configure the DS0 cross-connections.
Appendix A, Configuration Options
IMPORTANT:
All DSL time slots are available for cross-connect regardless of DSL line
rate, but all time slots are available for data transport only if the DSL line
rate is the full rate (1552 for DSX-1 or 2064 for G.703). Configure only the
time slots intended for use.
May 2002
4
, for information about
4-1