Paradyne 8779 User Manual page 137

Procedure
To test the inband management configuration:
8700-A2-GB20-40
7. Set Inband Management Select to Enable, and enter the port (1) and time slot
(1) to support Inband Management. Save your changes.
8. Use the Assign Time Slots screen to verify that Inband Management has been
assigned to Port 1 TS 1. Follow this menu selection sequence:
Main Menu Configuration
Assign Time Slots
The following screen appears:
main/config/cross_connect/timeslot
Slot: 18
G.703 Port: 1 DSOs to Allocate:
TS01 TS02 TS03
I D D
TS08 TS09 TS10
D D D
TS15 TS16 TS17
D D D
TS22 TS23 TS24
D D D
TS29 TS30 TS31
D D D
--------------------------------------------------------------------------------
Ctrl-a to access these functions, ESC for previous menu
Save
1. Connect the G.703 port to the MUX/DCAS to be used in the test.
2. Configure the upstream router for PPP mode. The router's WAN port should
be configured on the same IP address segment as the MCP card.
May 2002
Current Configuration
ASSIGN TIME SLOTS
Start TS:
TS04 TS05
D D D
TS11 TS12
D D D
TS18 TS19
D D D
TS25 TS26
D D D
Key: D = DSL,
d = data, v = voice
A. Configuration Options
Cross-Connect
Model: 8779
Assign To: D
TS06 TS07
D
TS13 TS14
D
TS20 TS21
D
TS27 TS28
D
G = G.703 I = IBMC
MainMenu Exit
Clear_All
A-41