Paradyne 8779 User Manual page 134

A. Configuration Options
Table A-16. Inband Management Channel Options – Model 8779
A-38
Inband Management Select
Possible Settings: Enable, Disable
Default Setting: Disable
Specifies whether data on the selected port and time slot will be sent according to the
cross-connect configuration or to the MCC card instead.
Enable – Enables the Inband Management Channel.
Disable – Disables the Inband Management Channel.
Inband Management Type
Possible Setting: PPP, Frame Relay
Default Setting: PPP
Specifies the type of data the Inband Management Channel will accept.
PPP – The Inband Managment Channel will accept Point-to-Point Protocol (PPP) data.
Frame Relay The Inband Management Channel will accept Frame Relay data.
Inband Management Port
Possible Settings: 1 – 8
Default Setting: 1
Selects the G.703 port for the Inband Management Channel. Only ports configured for
DS0 cross-connection or Unassigned are eligible for inband management.
Inband Management Time Slot
Possible Settings: 1 – 15 or 17 – 31
Default Setting: 1
Selects the G.703 time slot for the Inband Management Channel.
Inband Management DLCI
Possible Settings: 16 – 1007
Default Setting: 16
Selects the Data Link Connection Identifier (DLCI) the Inband Management Channel will
use when Inband Management Type is set to Frame Relay.
Inband Management LMI
Possible Settings: Annex A, Annex D, Standard
Default Setting: Standard
Selects the Local Management Interface (LMI) the Inband Management Channel will use
when Inband Management Type is set to Frame Relay.
Annex A The LMI supported is specified by Q933 Annex A.
Annex D The LMI supported is specified by ANSI T1.617 Annex D.
Standard The standard LMI is supported.
May 2002 8700-A2-GB20-40