Copy Ports Options - Paradyne 8779 User Manual

A. Configuration Options

Copy Ports Options

You can copy the configuration options of one DSX-1 or G.703 interface, or DSL
loop to another using the Copy Ports screen. For Copy Ports options, refer to
Table A-6, Copy Port
selection sequence:
Table A-6. Copy Port Options
A-12
Options. To access the Copy Ports screen, follow this menu
Main Menu Configuration
main/config/copy
Slot: 18
--------------------------------------------------------------------------------
ESC for previous menu
Save
From: Port n
Possible Settings: 1, 2, 3, 4, 5, 6, 7, 8
Default Setting: 1
Controls the source of the configuration options.
1– 8 – The configuration of the selected port is copied.
To: Port y
Possible Settings: 1, 2, 3, 4, 5, 6, 7, 8, All
Default Setting: 1
Controls the target of the configuration options.
1– 8 – The configuration of the selected port is replaced. If Perform Copy Then
Increment is selected, the port number is incremented by 1 after the copy.
All – The configurations of all ports are replaced by the configuration of the selected
From: Port.
NOTE: Peer IP Address and Circuit Identifier are not copied.
May 2002
Current Configuration
COPY PORTS
From: Port 1
To: Port 2
Perform Copy
Perform Copy Then Increment
Copy Ports
Model: 87xx
MainMenu Exit
8700-A2-GB20-40