Logging In To The Hotwire Dslam; Initiating An Ati Session - Paradyne 8779 User Manual

2. Using the Asynchronous Terminal Interface

Logging In to the Hotwire DSLAM

You can log in to the Hotwire DSLAM system using either a local
VT100-compatible terminal or a remote Telnet connection.
After you enter your user ID and password, the system displays the Hotwire
Chassis Main Menu. See your management card documentation for information
about selecting the unit from the card selection screen.

Initiating an ATI Session

The Main Menu screen is displayed unless a login ID and password is required or
the ATI is already in use.
If security is enabled on the termination unit and Telnet is used to access the unit
directly (you did not log in through the MCC), the system prompts you for a login
ID and password.
If you enter an invalid login ID and password three times, the Telnet session closes
or the terminal connection returns to an idle state. Refer to
If the ATI is already in use, the message connection refused is sent to a
terminal attempting Telnet access.
2-2
Login
Slot: 4
Login ID:
Enter Password:
--------------------------------------------------------------------------------
Ctrl-a to access these functions
May 2002
LOGIN
Model: 87xx
Exit
Chapter 6, Security .
8700-A2-GB20-40