Paradyne 8779 User Manual page 121

The following screen is displayed for a DSL port on a DSX-1 unit:
Select Clear_All to clear all time slot assignments for the port.
For an example showing how to configure the cross-connection system, see
Chapter 4, Cross-Connecting Ports
Refer to
these entries.
8700-A2-GB20-40
main/config/cross_connect/timeslot
Slot: 18
DSL Port: 1 DSOs to Allocate:
TS01 TS02
X d X d X
TS08 TS09
X d X d X
TS15 TS16
X d X d X
TS22 TS23
X d X d X
--------------------------------------------------------------------------------
Ctrl-a to access these functions, ESC for previous menu
Save
TS01
D 1 01 d
Port Type
(D = DSL
(G = G.703
X = DSX-1
I = IBMC)
Port Number
(1– 8)
Table A-11, Assign Time Slots
NOTES:
— If a G.703 port is configured for Signaling_CAS, time slot 16 is used for
signaling and is not available for cross-connection.
— Make sure that the number of DSL time slots defined are supported by the
DSL line rate. The maximum number of useful DSL time slots is the DSL
line rate divided by 64, rounded down to a whole number. See
Payload Rates and DSL Line Rates for Model
Payload Rates and DSL Line Rates for
available time slots at different DSL line rates.
May 2002
ASSIGN TIME SLOTS
Start TS:
TS03 TS04 TS05
d X d X
TS10 TS11 TS12
d X d X
TS17 TS18 TS19
d X d X
TS24
d
.
d (Data) or v (Voice)
Time Slot Number
(1–31)
Options, for additional information about
G.703, for more information on
A. Configuration Options
Model: 87xx
Assign To: D
TS06 TS07
d X d X d
TS13 TS14
d X d X d
TS20 TS21
d X d X d
Key: D = DSL, X = DSX-1
d = data, v = voice
MainMenu Exit
Clear_All
Table A-2,
8777, and Table A-3,
A-25