Snmp Traps Options - Paradyne 8779 User Manual

A. Configuration Options

SNMP Traps Options

An SNMP trap can be automatically sent out through the EOC or the Management
port to the SNMP manager when the unit detects conditions set by the user. These
traps enable the SNMP manager to gauge the state of the network. Refer to
Appendix B, Standards Compliance for SNMP
supported by the Hotwire Termination Unit.
To configure the unit for SNMP traps, use the SNMP Traps Options screen to:
T
T
T
T
To access the SNMP Traps Options screen, follow this menu selection sequence:
A-34
Enable SNMP traps.
Set the number of SNMP managers that receive SNMP traps from the unit.
Enter an IP address and network destination for each SNMP manager
specified.
Select the type of SNMP traps to be sent from the unit.
Main Menu Configuration
Management and Communication
main/config/management/trap
Slot: 4
SNMP Traps: Enable
NMS 1 IP Address: 135.014.040.001
NMS 2 IP Address: 135.014.003.027
NMS 3 IP Address: 135.014.001.008
NMS 4 IP Address: 135.014.002.024
NMS 5 IP Address: 204.128.146.035
NMS 6 IP Address: 135.014.003.028
NMS 7 IP Address: 135.014.001.009
NMS 8 IP Address: 135.014.002.025
NMS 9 IP Address: 204.128.146.036
General Traps: Both
Link Traps: Both
-------------------------------------------------------------------------------
Ctrl-a to access these functions, ESC for previous menu
Save
May 2002
Traps, for details of SNMP traps
Current Configuration
SNMP Traps
SNMP TRAPS OPTIONS
Number of Trap Managers: 9
Clear
Clear
Clear
Clear
Clear
Clear
Clear
Clear
Clear
Enterprise Specific Traps:
Link Traps Interfaces:
Model: 87xx
Disable
All
MainMenu Exit
8700-A2-GB20-40