Install Intake Manifold; Install No. 1 Secondary Air Injection Manifold; Cylinder Head Installation; Apply Seal Packing To Cylinder Block - Toyota 22R-E Service Manual

ENGINE – ENGINE MECHANICAL
(c) Install the EGR valve with the two bolts and nut.

9. INSTALL INTAKE MANIFOLD

(a) Position a new gasket on the cylinder head.
(b) Install the intake manifold with the delivery pipe and
injectors and No. 1 air pipe.
(c) Install the seven bolts, one hexagon bolt and two nuts.
Torque the bolts and nuts.
Torque: 19Nm (195kgf–cm, 14ft–lbf)
(d) Install the heater inlet pipe to the cylinder head with
the bolt.
(e) Install the PAIR valve with the two nuts.
Torque: 13N–m (130kgf–cm, 9 ft–lbf)
10. INSTALL NO. 1 SECONDARY AIR INJECTION
MANIFOLD
(a) Position new gaskets on the PAIR valve and No. 1
secondary air injection pipe.
(b) Install the No. 1 secondary air injection pipe with the
four nuts and bolt.
Torque: 13Nm (130kgf–cm. 9ft–lbf)

CYLINDER HEAD INSTALLATION

(See page EG1–15)

1. APPLY SEAL PACKING TO CYLINDER BLOCK

(a) Apply seal packing to two locations as shown.
Seal packing: Part No. 08826–00080 or equivalent
(b) Place a new head gasket over dowels on the cylinder
block.
2. INSTALL CYLINDER HEAD
EG1–33