Oil And Filter Replacement; Drain Engine Oil; Replace Oil Filter; Fill With Engine Oil - Toyota 22R-E Service Manual

EG1–236
ENGINE – LUBRICATION SYSTEM

OIL AND FILTER REPLACEMENT

CAUTION:
Prolonged and repeated contact with mineral oil will
result in the removal of natural fats from the skin,
leading to dryness, irritation and dermatitis. In ad–
dition, used engine oil contains potentially harmful
contaminants which may cause skin cancer.
Adequate means of skin protection and washing
facilities should be provided.
Care should be taken, therefore, when changing
engine oil, to minimize the frequency and length of
time your skin is exposed to used engine oil.
Protective clothing and gloves, that cannot be pen–
etrated by oil, should be worn. The skin should be
thoroughly washed with soap and water, or use
waterless hand cleaner, to remove any used engine
oil. Do not use gasoline, thinners, or solvents.
In order to preserve the environment, used oil and
used oil filters must be disposed of only at desig–
nated disposal sites.

1. DRAIN ENGINE OIL

(a) Remove the oil filter cap.
(b) Remove the oil dipstick.
(c) Remove the oil drain plug and drain the oil into a
container.

2. REPLACE OIL FILTER

(a) Using SST, remove the oil filter (located on right side
of the engine block).
SST 09228–07500
(b) Clean the filter contact surface on the filter mounting.
(c) Lubricate the filter rubber gasket with engine oil.
(d) Tighten the filter by hand until the gasket contacts the
seat of the filter mounting. Then using SST, give it an
additional 3/4 turn to seat the filter.
SST 09228–07500

3. FILL WITH ENGINE OIL

(a) Clean and install the oil drain plug with a new gasket.
(b) Fill the engine with new oil, API grade SG multigrade,
fuel efficient and recommended viscosity oil.