Remove Engine Rear Mounting Bracket - Toyota 22R-E Service Manual

ENGINE – ENGINE MECHANICAL
19. REMOVE FRONT EXHAUST PIPE
(a) Disconnect the heated oxygen sensor connector.
(b) Loosen the pipe clamp bolt.
(c) Remove the two bolts and pipe bracket.
(d) Remove the three nuts, and disconnect the exhaust
pipe from the exhaust manifold. Remove the gasket.
(e) Remove the two bolts, joint retainer, exhaust pipe and
gasket from the catalytic converter.
20. (M/T only)
REMOVE SHIFT LEVERS
21. REMOVE REAR PROPELLER SHAFT
(See page PR–5)
22. (4WD only)
REMOVE FRONT PROPELLER SHAFT
(See page PR–5)
23. (4WD A/T only)
DISCONNECT MANUAL SHIFT LINKAGE
24. DISCONNECT SPEEDOMETER CONNECTOR
NOTICE: Do not lose the felt dust protector and washers.
25. (4WD only)
REMOVE TRANSFER UNDER COVER
26. (4WD only)
REMOVE STABILIZER BAR
27. REMOVE NO.1 FRAME CROSSMEMBER
28. REMOVE N0.1 FRONT FLOOR HEAT INSULATOR
AND BRAKE TUBE HEAT INSULATOR (4WD)
29. (2WD)

REMOVE ENGINE REAR MOUNTING BRACKET

(a) Remove the four bolts holding the mounting bracket
to the mounting insulator.
EG2–93