Toyota 22R-E Service Manual page 505

EG2–228
ENGINE – MFI SYSTEM
4. INSTALL AIR INTAKE CHAMBER
(a) Position a new gasket on the intake manifold.
(b) Install the intake chamber with the six bolts and two
nuts.
Torque: 18 N–m (185 kgf–cm, 13 ft–lbf)
(c) Install the accelerator cable bracket with the two
bolts.
(d) Connect the four vacuum hoses to the air pipes.
(e) Connect the No.1 air hose to the reed valve.
(f) Position two new gaskets to the intake chamber and
RH exhaust manifold.
(g) Install the EGR valve with the pipes to the intake
chamber and RH exhaust manifold.
(h) (C & C only)
Connect the two water by–pass hose to the EGR
valve.
(i) Install the air intake chamber stay and throttle cable
bracket. Install and torque the six nuts and two bolts.
Torque:
(A) 29 N–m (300 kgf–cm, 22 ft–lbf)
(B) 18 N–m (185 kgf–cm, 13 ft–lbf)