Post Assembly - Toyota 22R-E Service Manual

EG2–122
ENGINE – ENGINE MECHANICAL

POST ASSEMBLY

(See Components)
1. INSTALL OIL PUMP
(a) Remove any old packing (FIPG) material and be car–
eful not to drop any oil on the contact surfaces of the
oil pump and cylinder block.
Using a razor blade and gasket scraper, remove
all the old packing (FIPG) material from the
gasket surfaces and sealing groove.
Thoroughly clean all components to remove all
the loose material.
Using a non–residue solvent, clean both sealing
surfaces.
(b) Apply seal packing to the oil pump as shown in the
illustration.
Seal packing:
Part No. 08826–00080 or equivalent
NOTICE: Avoid applying en excessive amount to the
surface. Be particularly careful near oil passage.
Install a nozzle that has been cut to a 2 – 3 mm
(0.08 – 4.12 in.) opening.
Parts must be assembled within 5 minutes of
application. Otherwise the material must be re–
moved and reapplied.
Immediately remove nozzle from the tube and
reinstall cap.
(c) Install a new O–ring to the cylinder block.