Install Head Cover; Post Installation; Connect Ps Bracket To Cylinder Head (W/Ps); Connect By–Pass Hose To Intake Manifold - Toyota 22R-E Service Manual

EG1–36
ENGINE – ENGINE MECHANICAL

8. INSTALL HEAD COVER

(a) Apply seal packing to the four locations shown.
Seal packing: Part No. 08826–00080 or equivalent
(b) Install the gasket to the cylinder head.
(c) Place the head cover on the cylinder head and install
the four seals and nuts.
Torque: 5.9N–m (60kgf–cm, 52in.–Ibf)

POST INSTALLATION

1. (w/PS)
CONNECT PS BRACKET TO CYLINDER HEAD
Install the four bolts and bond strap. Torque the bolts.
Torque: 44N–m (450kgf–cm, 33ft–lbf)
2. (w/PS)
INSTALL DRIVE BELT AND ADJUST BELT TEN–
SION
(See step 2 on page MA–6)
3. CONNECT BY–PASS HOSE TO INTAKE MANIFOLD
4. CONNECT FUEL HOSE TO DELIVERY PIPE
Install new gaskets and the fuel hose with union bolt.
Torque: 44N–m (450kgf–cm, 33ft–lbf)
5. CONNECT FOLLOWING WIRES:
(a) Engine coolant temp. sensor wire
(b) Cold start injector time switch wire
(c) VSV wires
(d) Igniter wire