Clean Oil Pan Baffle Plate And Oil Pan - Toyota 22R-E Service Manual

ENGINE – LUBRICATION SYSTEM
Install nozzle that has been cut out to a 2–3 mm
(0.08–0.12 in.) opening.
HINT: Avoid applying an excessive amount to the
surface.
Parts must be assembled within 5 minutes of
application. Otherwise the material must be re–
moved and reapplied.
Immediately remove nozzle from the tube and
reinstall cap.
(c) Place a new O–ring into the groove of cylinder block.
(d) Install the oil pump to the crankshaft with the spline
teeth of the drive rotor engaged with the large teeth
of the crankshaft.
(e) Install the oil pump with the seven bolts.
Torque: 20 N–m (200 kgf–cm, 14 ft–lbf)

2. CLEAN OIL PAN BAFFLE PLATE AND OIL PAN

Remove any old packing (FIPG) material and be car–
eful not to drop any oil on the contacting surfaces of
the oil pan baffle plate, oil pan, cylinder block and
sealing grooves.
Using a razor blade and gasket scraper, remove
all the remaining seal packing (FIPG) material
from the gasket surfaces.
Thoroughly clean all components to remove all
the loose material.
Clean both sealing surfaces with a non–residue
solvent.
NOTICE: Do not use a solvent which will affect the pai–
nted surfaces.
EG2–285