Terminals
No.
ENGINE
Trouble
No voltage
(1) There is no voltage between ECM terminals No. 10 and/or
No. 20 and E01, and/or E02– (IG SW ON)
(2) Check that there is voltage between ECM terminal No. 10
and/or No. 20 and body ground.
Check fusible link and ignition
switch.
(3) Check resistance of magnetic coil in each injector.
STD resistance: 13.4 – 14.2
Check wiring between ECM
terminal No. 10 and/or
No. 20 and battery.
–
MFI SYSTEM
Condition
Ignition switch ON
Check wiring between ECM terminal E01, and/or E02
and body ground.
Try another ECM.
W
EG1–151
STD Voltage
BAD
Repair or replace.
Repair or replace.
BAD
Replace injector.
BAD
Repair or replace.