Install Intake Manifold - Toyota 2L-T Repair Manual

EM-44 ENGINE MECHANICAL
-
Cvlinder Head (2L-T)
INSTALL INTAKE MANIFOLD
(a)
lnstall a new gasket and the intake manifold with the
six bolts and two nuts.
Torque: 240 kg-cm (17 ft-lb, 24 N-m)
HINT: Torque the three bolts on the bottom of the
manifold together with the oil level gauge guide support
and the clamp for the engine wires, as shown in the illustra-
tion.
(b) lnstall the insulator and nut to the glow plug resistor.
HINT: lnstall the insulator and engine wire terminals as
shown in the illustration.
(Austria)
INSTALL EGR VALVE, PIPE, VALVE ADAPTOR AND
CONTROL VALVE ASSEMBLY
(a) Place a new gasket in position on the intake manifold.
(b) lnstall the EGR valve and pipe with the two nuts.
Torque:
130 kg-cm (9 in.-lb, 13 N-m)
(c)
l nstall the EG R control valve assembly with the three
bolts.
(d) Connect the connectors to the VSV and EVRV.
(e) lnstall two new gaskets, the EGR valve adaptor and
air pipe ( L N only) with the four nuts.
Torque: 195 kg-cm (14 ft-lb, 19 N-m)