EG1–204
ENGINE
–
MFI SYSTEM
AUXILIARY AIR VALVE
ON –VEHICLE INSPECTION
CHECK OPERATION OF AUXILIARY AIR VALVE
Check the engine rpm by fully screwing in the idle
speed adjusting screw.
At low temp. (Coolant temp.: below 80SC/176SF)
When the idle speed adjusting screw is in, the
engine rpm should drop.
After warm–up
When the idle speed adjusting screw is in, the
engine rpm should drop below idle speed stop.
AUXILIARY AIR VALVE REMOVAL
1. REMOVE THROTTLE BODY
(See page EG1–200)
2. REMOVE AUXILIARY AIR VALVE
(See step 2 on page EG1–202)
AUXILIARY AIR VALVE INSTALLATION w
1. INSTALL AUXILIARY AIR VALVE
(See step 2 on page EG1–202)