Check Seating Of Egr Valve; Check Vsv With A Cold Engine; Check Vsv And Egr Vacuum Modulator With Hot Engine - Toyota 22R-E Service Manual

Table of Contents

Advertisement

ENGINE
EMISSION CONTROL SYSTEMS
EGR SYSTEM INSPECTION
1. CHECK AND CLEAN FILTER IN EGR VACUUM
MODULATOR
(a) Check the filter for contamination or damage.
(b) Using compressed air, clean the filter.
2. PREPARATION
Disconnect the vacuum hose from the EGR valve, and
using a three way union, connect a vacuum gauge to
it.

3. CHECK SEATING OF EGR VALVE

Start the engine and check that the engine starts and
runs at idle.
4. CHECK VSV WITH COLD ENGINE
(a) The coolant temperature should be below 34 SC (93S
F).
(b) Check that the vacuum gauge indicates zero at 3,500
rpm.
5. CHECK VSV AND EGR VACUUM MODULATOR
WITH HOT ENGINE
(a) Warm up the engine.
(b) Check that the vacuum gauge indicates low vacuum
at 3,500 rpm.
(c) Disconnect the vacuum hose from R port of the EGR
vacuum modulator and connect R port directly to the
intake manifold with another hose.
(d) Check that the vacuum gauge indicates high vacuum
at 3,000 rpm.
HINT: As a large amount of EGR gas enters, the
engine will misfire slightly at this time.
(e) Disconnect the vacuum gauge and reconnect the
vacuum hoses to the proper locations.
EG1–93

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

22r3vz-e

Table of Contents