EG2–52
ENGINE
–
ENGINE MECHANICAL
9. REMOVE COOLING FAN
Remove the four nuts and cooling fan.
10. REMOVE GENERATOR DRIVE BELT
11. DISCONNECT STRAP, WIRES, CONNECTORS.
HOSES AND CABLES
(a) Disconnect the following strap, wires and connectors:
Ground strap from LH fender apron
Generator connector and wire
Igniter connector
Oil pressure sender gauge connector
Ground strap from engine rear side
ECM connectors
VSV connectors
A/C compressor connector
(M/T only)
Starter relay connector
Solenoid resister connector
Data link connector 1
(w/ ADD)
ADD switch connector
(b) Disconnect the following hoses:
PS air hoses from gas filter and air pipe
Brake booster hose
(w/ Cruise Control System)
Cruise control vacuum hose
Charcoal canister hose from canister
VSV vacuum hoses
(c) Disconnect the following cables:
Accelerator cable
(A/T only)
Throttle cable
(w/ Cruise Control System)
Cruise control cable
12. DISCONNECT HEATER HOSES
13. DISCONNECT FUEL INLET AND OUTLET HOSES