ENGINE
–
MFI SYSTEM
3. INSPECT DASHPOT (DP)
A. Warm up engine
Allow the engine to warm up to normal operating
temperature.
B. Check idle speed and adjust, if necessary
(See page EG2–27)
Idle speed:
800
50 rpm
C. Remove cap, filter and separator from DP
D. Check and adjust DP setting speed
(a) Maintain engine speed at 2,500 rpm or more.
(b) Plug the VTV hole with your finger.
(c) Release the throttle valve.
(d) Check the DP is set.
DP setting speed:
2,000
200 rpm
(e) If not as specified, adjust with the DP adjusting screw.
EG2–237