Install Oil Pan; Install Oil Filter Union - Toyota 22R-E Service Manual

EG2–124
ENGINE – ENGINE MECHANICAL
3. INSTALL OIL STRAINER
Install a new gasket and the oil strainer with the two
nuts and two bolts.
Torque: 6.9 N–m (70 kgf–cm, 61 in. –lbf)

4. INSTALL OIL PAN

(a) Remove any old packing (FIPG) material and be ear–
eful not to drop any oil on the contact surfaces of the
oil pan and baffle plate.
Using a razor blade and gasket scraper, remove
all the old packing (FIPG) material from the
gasket surfaces and sealing groove.
Thoroughly clean all components to remove all
the loose material.
Using a non–residue solvent, clean both sealing
surfaces.
(b) Apply seal packing to the oil pan as shown in the
illustration.
Seal packing:
Part No. 08826–00080 or equivalent
Install a nozzle that has been cut to a 3 – 4 mm
(0.12 – 0.16 in.) opening.
Parts must be assembled within 5 minutes of
application. Otherwise the material must be re–
moved and reapplied.
Immediately remove nozzle from the tube and
reinstall cap.
(c) Install the oil pan with the two nuts and seventeen
bolts.
Torque: 5.9 N–m (60 kgf–cm, 52 in.–lbf)

5. INSTALL OIL FILTER UNION

Using a 12 mm hexagon wrench, install and torque
the oil filter union.
Torque: 25 N–m (250 kgf–cm, 18 ft–lbf)