Cylinder Block Assembly; Install Rear Oil Seal Retainer; Install Oil Strainer; Install Flywheel Or Drive Plate - Toyota 22R-E Service Manual

EG1–70
ENGINE – ENGINE MECHANICAL
(c) Apply a light coat of engine oil on the threads and
under the rod nuts.
(d) Install and tighten the rod nuts alternately and in two
or three passes.
Torque: 69 N–m (700 kgf–cm, 51 ft–lbf)
(e) Check that the crankshaft turns smoothly.
(f) Check the rod thrust clearance.
(See page EG1–51)

CYLINDER BLOCK ASSEMBLY

(See page EG1–46)

1. INSTALL REAR OIL SEAL RETAINER

Install a new gasket and the retainer with the four
bolts. Torque the bolts.
Torque: 18 N–m (180 kgf–cm, 13 ft–lbf)

2. INSTALL OIL STRAINER

(a) Clean the oil strainer.
(b) Place the gasket in place and install the oil strainer
assembly with the four bolts. Torque the bolts.
Torque: 13 N–m (130 kgf–cm, 9 ft–lbf)
3. INSTALL FUEL FILTER BRACKET AND FILTER
4. INSTALL KNOCK CONTROL SENSOR
5. INSTALL OIL PRESSURE SENDER GAUGE
6. (A/T)
INSTALL FLEXIBLE HOSE CLAMP
7. INSTALL RH ENGINE MOUNTING BRACKET, CHA–
MBER STAY AND GROUND STRAP
8. INSTALL OIL FILTER
(See step 2 on page EG1–236)
9. INSTALL CHAIN TENSIONER
Torque: 19 N–m (195 kgf–cm, 14 ft–lbf)
10. INSTALL CHAIN DAMPERS
Torque: 22 N–m (220 kgf–cm, 16 ft–lbf)
11. INSTALL GENERATOR BRACKET AND LH ENGINE
MOUNTING BRACKET
12. INSTALL TIMING CHAIN (See page EG1–43)
13. INSTALL GENERATOR
14. INSTALL CYLINDER HEAD (See page EG1–34)
15. REMOVE ENGINE STAND
16. INSTALL REAR END PLATE

17. INSTALL FLYWHEEL OR DRIVE PLATE

Install the flywheel (M / T) or spacer, drive plate,
spacer (A/T) on the crankshaft with the six bolts.
Torque the bolts.